2005-2008 Yaris · Service Manual BODY

DATA LIST / ACTIVE TEST

System information · Vehicles built from Aug 2005


READ DATA LIST

HINT:
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Read the Data List.

Power window regulator master switch assembly: 
Item
Measurement Item/ Display (Range)
Normal Condition
Diagnosis Note
Door P/W Auto SW
Driver side power window auto UP/DOWN switch signal/
ON or OFF
ON: Driver side power window auto UP/DOWN switch on master switch operated
OFF: Driver side power window switch on master switch not operated
-
Door P/W Up SW
Driver side power window manual UP/DOWN switch signal/
ON or OFF
ON: Driver side power window manual UP switch on master switch operated
OFF: Driver side power window switch on master switch not operated
-
Door P/W Down SW
Driver side power window manual DOWN switch signal/
ON or OFF
ON: Driver side power window manual DOWN switch on master switch operated
OFF: Driver side power window switch on master switch not operated
-
Glass Position (Close - 1/4)
Jam protection operation within range of fully closed to 1/4 open window glass position/
OK or CAUTION
OK: Jam protection dose not operate
CAUTION: Jam protection dose not operates
-
Glass Position (1/4 - 2/4)
Jam protection operation within range of 1/4 to 1/2 open window glass position/
OK or CAUTION
OK: Jam protection dose not operate
CAUTION: Jam protection dose not operates
-
Glass Position (2/4 - 3/4)
Jam protection operation within range of 1/2 to 3/4 open window glass position/
OK or CAUTION
OK: Jam protection dose not operate
CAUTION: Jam protection dose not operates
-
Glass Position (3/4 - Open)
Jam protection operation within range of 3/4 to fully open window glass position/
/OK or CAUTION
OK: Jam protection dose not operate
CAUTION: Jam protection dose not operates
-
Main body ECU: 
Item
Measurement Item/ Display (Range)
Normal Condition
Diagnostic Note
Communication D Door Motor
Connection status between power window regulator motor assembly (driver door) and main body ECU/
OK/Stop
OK: Connection
Stop: No connection
-
D Dor Cty SW
Driver side door courtesy switch signal/
ON/OFF
ON: Driver door open
OFF: Driver door closed
-

PERFORM ACTIVE TEST

NOTICE:
Be careful to avoid injuries as this test causes vehicle parts to move.

HINT:
Performing the intelligent tester's Active Test allows relay, VSV, actuator, and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The data list can be displayed during the Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Performing the Active Test by following the prompts on the tester screen.

Power window regulator master switch assembly: 
Item
Test Details
Diagnostic Note
Power window
OFF/UP/DOWN(OFF)
-
Main body ECU: 
Item
Test Details
Diagnostic Note
IG OFF P/W
ON/OFF
-
← FAIL-SAFE CHART (from Aug 2005)DIAGNOSTIC TROUBLE CODE CHART (from Aug 2005) →