2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY

I101159
  1. Engage the 2 claws and connect the air inlet damper control cable.


2. CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY

I101158
  1. Engage the 2 claws and connect the defroster damper control cable.


3. CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY

I101157
  1. Engage the 2 claws and connect the air mix control cable clamp.

  1. Connect the defroster damper control cable to the clamp.


4. INSTALL AIR CONDITIONING PANEL ASSEMBLY

I101156
  1. Connect the 3 connectors and the clamp.

  1. I101155
    Engage the 3 clips and 2 claws and install the air conditioning panel.


5. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY (Except CD Player)

I101576
  1. Engage the 4 clips and 2 claws and install the instrument cluster finish panel center.


6. INSTALL RADIO RECEIVER ASSEMBLY (w/ CD Player)

I101590
  1. Connect the connectors.

  1. Engage the 4 clips and 2 claws and install the radio receiver.

  1. Install the 4 screws.


7. INSTALL INSTRUMENT CLUSTER FINISH PANEL

B132366E01
  1. Fit the 3 A claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.

  1. B132367
    Engage the 4 claws and 5 clips and install the instrument cluster finish panel.


8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

E107743
  1. with CD player

    1. Connect the connector.

    2. Engage the 4 claws and 3 clips and install the instrument panel finish panel end RH.

  1. E107744
    Except CD player

    1. Connect the connector.

    2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end RH.


9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

E107741
  1. with CD player

    1. Connect the connector.

    2. Engage the 4 claws and 3 clips and install the instrument panel finish panel end LH.

  1. E107742
    Except CD player

    1. Connect the connector.

    2. Engage the 5 claws and 3 clips and install the instrument panel finish panel end LH.


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Aug 2005)PRECAUTION (from Nov 2005) →