DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built from Aug 2005
| DESCRIPTION |
When troubleshooting a vehicle with a diagnosis system, connect an intelligent tester to the DLC3 of the vehicle and read various data output from the steering lock ECU.
The steering lock ECU records DTCs when the computer detects a malfunction in the computer itself or in its circuits.The diagnosis information of the steering lock ECU is transmitted to the tester via the certification ECU as the steering lock ECU is not connected to the CAN communication system.
The steering lock ECU does not store DTCs regarding past problems.
- HINT:
- When the engine switch is off, the main body ECU may not be working.
- Communication with the intelligent tester is impossible if the main body ECU is not working.
| CHECK DLC3 |
The certification ECU follows the ISO 9141-2 (Euro-OBD) communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 9141-2 format.

Symbols (Terminals No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus [+] line
During communication
Pulse generation
CG (4) - Body ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
- HINT:
- If the display shows [UNABLE TO CONNECT TO VEHICLE] after connecting the intelligent tester cable to the DLC3 and turning the engine switch on (IG), there is a problem with either the vehicle or tester.
- If communication is normal when connecting the tester to another vehicle, inspect the DLC3 on the original vehicle.
- If communication is still not possible when connecting the tester to another vehicle, the problem is probably on the tester itself. Consult the Service Department listed in the tester's operator's manual.
- If communication is normal when connecting the tester to another vehicle, inspect the DLC3 on the original vehicle.