DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2005
| DATA LIST |
- HINT:
- By accessing the DATA LIST displayed on the intelligent tester, you can read values of switches and sensors without removing any parts.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Operate the intelligent tester according to the prompts displayed on the tester and select DATA LIST.
Certification ECU: Item
Measurement Item/
Range (Display)
Normal Condition
Sensor Value
Sensor malfunction/
NG (Past) or OK
NG (Past): Sensor malfunction
OK: No malfunction
Power Supply Short
Short in ECU/
NG (Past) or OK
NG (Past): Short in ECU
OK: No malfunction
Power Supply Open
Open in ECU/
NG (Past) or OK
NG (Past): Open in ECU
OK: No malfunction
Motor Driver Short
Short in driver ECU/
NG (Past) or OK
NG (Past): Short in driver ECU
OK: No malfunction
Motor Driver Open
Open in driver ECU/
NG (Past) or OK
NG (Past): Open in driver ECU
OK: No malfunction
Lock / Unlock Receive
Steering lock command reception record/
YES or NO
YES: Steering lock / unlock signal received
NO: Steering lock / unlock signal not received
Lock Bar Stuck Error
Lock bar stuck malfunction/
NG (Past) or OK
NG (Past): Lock bar stuck malfunction
OK: No malfunction
Push Start Error
Push button start function malfunction/
NG (Past) or OK
NG (Past): Malfunction in push button start
OK: No malfunction
IG2 Status
IG2 voltage/
ON or OFF
ON: 10 to 14 V
OFF: Below 1 V
IG (Lin)
LIN bus start-up status/
ON or OFF
ON: LIN bus started-up
OFF: LIN bus not started-up
S Code Check
S code match record/
NG or OK
NG: S code not matched
OK: S code matched
L Code Check
L code match record/
NG or OK
NG: L code not matched
OK: L code matched