2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.

  1. I101550E01
    Remove the caps from the service valves on the refrigerant line.

  1. Connect the Freon collection/recycling device to discharge the refrigerant gas remaining in the refrigeration system.

    NOTICE:
    Use the Freon collection/recycling device in accordance with the manufacturer's instruction manual.


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE FRONT BUMPER COVER

  1. B134799E01
    Apply protective tape, as shown in the illustration.

  1. B134803
    Remove the 7 screws and 3 bolts.

  1. Remove the 2 screw grommets.

  1. Remove the 6 clips.

  1. B134801
    w/ Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

    2. Disconnect the 2 fog light connectors.

  1. B134800
    w/o Fog Light:

    1. Disengage the 6 claws and remove the front bumper cover.

  1. B134823
    Remove the 2 clips and the screw grommet.


4. REMOVE NO. 1 COOLER COVER

A109229
  1. Remove the 2 clips and cooler cover No. 1.


5. SEPARATE HOOD LOCK ASSEMBLY

A104889
  1. Separate the hood lock control cable assembly from the 2 clamps.

  1. A104888
    Remove the 3 bolts and remove the hood lock assembly.


6. REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER

A128451E01
  1. Separate the horn assembly connector.

  1. Remove the 4 bolts and remove the radiator support sub-assembly upper.


7. REMOVE FAN SHROUD VENTILATION DUCT ASSEMBLY (w/ Fan Shroud Ventilation Duct)

I102576
  1. Disengage the 4 claws and remove the fan shroud ventilation duct from the vehicle.


8. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

I102632E01
  1. Remove the bolt and disconnect the discharge hose from the cooler condenser.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


9. DISCONNECT LIQUID TUBE SUB-ASSEMBLY

I101533
  1. Remove the bolt and separate the liquid tube bracket (w/ Fan Shroud Ventilation Duct).

  1. I102633E01
    Remove the bolt and disconnect the liquid tube from the cooler condenser.

  1. Remove the O-ring from the liquid tube.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


10. REMOVE COOLER CONDENSER ASSEMBLY

I102579
  1. Disengage the 2 claws and remove the condenser from the vehicle.

    NOTICE:
    Do not damage the condenser or radiator when removing the condenser.

← ON-VEHICLE INSPECTION (from Jan 2006)DISASSEMBLY (from Jan 2006) →