1.
DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
Remove the caps from the service valves on the refrigerant line.
Connect the Freon collection/recycling device to discharge the refrigerant gas remaining in the refrigeration system.
NOTICE:
Use the Freon collection/recycling device in accordance with the manufacturer's instruction manual.
2.
REMOVE FRONT SPOILER COVER LH (w/ Front Spoiler)
Remove the 5 screws and the front spoiler cover.
3.
REMOVE FRONT SPOILER COVER RH (w/ Front Spoiler)
Remove the 4 screws and the front spoiler cover.
4.
REMOVE FRONT BUMPER COVER
Apply protective tape as shown in the illustration.
w/ Front Spoiler:
Remove the 3 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/o Front Spoiler:
Remove the 8 screws.
Remove the 2 screw grommets.
Remove the 7 clips.
w/ Fog Light:
Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/o Fog Light:
Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
w/ Front Spoiler:
Remove the 2 clips and the 4 screw grommets.
w/o Front Spoiler:
Remove the 2 clips and the screw grommet.
5.
REMOVE FRONT BUMPER COVER (for Sport Package)
Apply protective tape as shown in the illustration.
Remove the 5 screws and the 3 bolts.
Remove the 2 screw grommets.
Remove the 7 clips.
Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
Remove the 2 clips, the 2 spring nuts and the screw grommet.
6.
REMOVE RADIATOR SUPPORT ABSORBER UPPER
Disengage the 6 claws and remove the radiator support absorber upper.
7.
REMOVE NO. 1 COOLER COVER
Remove the 2 clips and cooler cover No. 1.
8.
SEPARATE HOOD LOCK ASSEMBLY
Separate the hood lock control cable assembly from the 2 clamps.
Remove the 3 bolts and remove the hood lock assembly.
9.
REMOVE RADIATOR SUPPORT SUB-ASSEMBLY UPPER
Separate the horn assembly connector.
Remove the 4 bolts and remove the radiator support sub-assembly upper.