B2276 ACCR Signal Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
This DTC is output when a malfunction is detected in the ACCR signal output by the main body ECU.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2276 |
ACCR output circuit inside main body ECU or other related circuit is malfunctioning |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear the DTCs.
Check whether DTC B2276 recurs 50 seconds or more after the ignition switch is turned on (IG).
- Result:
Display (DTC output)
Proceed To
B2276
A
No DTC output
B
|
|
||||
| A | |
| 2. INSPECT MAIN BODY ECU |
Disconnect the D66 main body ECU connector.

Measure the voltage between the ECU terminal and the body ground when operating the ignition switch to start cranking.
- Standard voltage:
Tester Connections
Specified Conditions
ACCR (D66-11) - Body ground
10 to 14 V
Reconnect the main body ECU connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
Disconnect the D66 main body ECU connector.

Disconnect the A21 ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D66-11 (ACCR) - A21-13 (ACCR)
Below 1 Ω
D66-11 (ACCR) or A21-13 (ACCR) - Body ground
10 kΩ or higher
Reconnect the ECM connector.
Reconnect the main body ECU connector.
|
|
||||
| OK | |
| 4. CHECK MAIN BODY ECU |
Temporarily replace the main body ECU with a new or normally functioning one.
Check whether DTC B2276 recurs by repeating procedure 1.
- OK:
- No DTC output.
|
|
||||
| OK | ||
| ||
