2005-2008 Yaris · Service Manual ENGINE

B2276 ACCR Signal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2006

DESCRIPTION

This DTC is output when a malfunction is detected in the ACCR signal output by the main body ECU.
DTC No.
DTC Detection Condition
Trouble Area
B2276
ACCR output circuit inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU
  2. SFI system (2ZR-FE)
  3. Wire harness

WIRING DIAGRAM

A122229E19

INSPECTION PROCEDURE


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear the DTCs.

  1. Check whether DTC B2276 recurs 50 seconds or more after the engine switch is turned on (IG).

    Result:
    Display (DTC output)
    Proceed To
    B2276
    A
    No DTC output
    B



B
SYSTEM IS OK
A


2. INSPECT MAIN BODY ECU

  1. A122230E02
    Disconnect the D66 main body ECU connector.

  1. Measure the voltage between the ECU terminal and the body ground when operating the engine switch to start cranking.

    Standard voltage:
    Tester Connections
    Specified Conditions
    D66-11 (ACCR) - Body ground
    11 to 14 V

  1. Reconnect the main body ECU connector.



NG
Go to step 4
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)

  1. A130562E02
    Disconnect the D66 main body ECU connector.

  1. Disconnect the A21 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D66-11 (ACCR) - A21-13 (ACCR)
    Below 1 Ω
    D66-11 (ACCR) or A21-13 (ACCR) - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK MAIN BODY ECU
  1. Temporarily replace the main body ECU with a new or normally functioning one.

  1. Check whether DTC B2276 recurs by repeating procedure 1.

    OK:
    No DTC output.



NG
GO TO SFI SYSTEM (2ZR-FE)
OK

END (MAIN BODY ECU IS FAULTY)


← B2275 STSW Monitor Malfunction (from Nov 2006)B2277 Detecting Vehicle Submersion (from Nov 2006) →