B2278 Engine Switch Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC is output when 1) a malfunction is detected between the main body ECU and the ignition switch; or 2) either of the switches inside the ignition switch is malfunctioning.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2278 |
Communication is abnormal between main body ECU and ignition switch or ignition switch is defective |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE OF INTELLIGENT TESTER (START SWITCH 1 AND 2) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Body / Main Body ECU / Data List / St SW1 and St SW2.
Read the value displayed on the tester.
- Main Body ECU:
Item
Measurement Item/Display (Range)
Normal Condition
Diagnostic Note
St SW1
Start Switch 1 / ON or OFF
ON: Ignition switch on (IG)
OFF: Ignition switch off
-
St SW 2
Start Switch 2 / ON or OFF
ON: Ignition switch on (IG)
OFF: Ignition switch off
-
- OK:
- ON appears on the screen.
|
|
||||
| OK | |
| 2. CHECK SWITCH CONDITION (IGNITION SWITCH) |
Ensure the electrical key is inside the cabin.
Check that the power source mode changes as shown below each time the ignition switch is.
- OK:
- off → on (ACC) → on (IG) → off
|
|
||||
| OK | ||
| ||
| 3. INSPECT IGNITION SWITCH ASSEMBLY |
![]() ![]() |
Remove the ignition switch.
Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
7 (SS1) - 5 (GND)
Pushed
Below 1 Ω
2 (SS2) - 5 (GND)
Pushed
Below 1 Ω
7 (SS1) - 5 (GND)
Not pushed
10 kΩ or higher
2 (SS2) - 5 (GND)
Not pushed
10 kΩ or higher
Reinstall the ignition switch.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (IGNITION SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the D55 ignition switch connector.

Disconnect the D65 main body ECU connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D55-7 (SS1) - D65-10 (SSW1)
Below 1 Ω
D55-2 (SS2) - D65-9 (SSW2)
Below 1 Ω
D55-5 (GND) - Body ground
Below 1 Ω
D55-7 (SS1) or D65-10 (SSW1) - Body ground
10 kΩ or higher
D55-2 (SS2) or D65-9 (SSW2) - Body ground
10 kΩ or higher
Reconnect the main body ECU connector.
Reconnect the ignition switch connector.
|
|
||||
| OK | ||
| ||

