2005-2008 Yaris · Service Manual BODY

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Aug 2005


CHECK DTC (Using an intelligent tester)
  1. Connect an intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG) and turn the tester ON.

  3. Select the following menu items: Body / Power Window / DTC.

  4. Check the DTC(s).


CLEAR DTC (Using an intelligent tester)
  1. Connect an intelligent tester to the DLC3.

  2. Turn the ignition switch to on (IG) and turn the tester ON.

  3. Select the following menu items: Body / Power Window / DTC / Clear.

  4. Press the YES button.

  5. Check that DTCs are cleared.


CLEAR DTC (Without using an intelligent tester)
  1. Perform either of the following operations.

    1. Disconnect the negative battery cable for more than 1 minute.

    2. Remove the ECU-B fuse from the engine room relay block located inside the engine compartment for more than 1 minute.

← DIAGNOSIS SYSTEM (from Aug 2005)FAIL-SAFE CHART (from Aug 2005) →