PRECAUTION
Precautions · Vehicles built from Nov 2005
| 1.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
LOCK
Off
Ignition Switch on (IG)
ON
On (IG)
Ignition Switch on (ACC)
ACC
On (ACC)
Engine Start
START
Start
| 2.PRECAUTIONS WHEN USING INTELLIGENT TESTER |
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals push the switch with your finger until communication between the tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned on (IG).
| 3.PRECAUTIONS ENTRY AND START FUNCTION |
Before starting the engine, firmly depress the clutch pedal (M/T) or brake pedal (except M/T) until the indicator of the ignition switch lights up green.
The power source mode (off, on (ACC), on (IG)) is always stored in the vehicle. After the battery is disconnected and reconnected, the power source condition before battery disconnection will be restored. Be sure to turn the ignition switch off before disconnecting the cable from the battery terminal. Be careful if the power source condition before the battery became depleted is not known.
After the battery is disconnected and reconnected, be sure to wait 10 seconds or more before starting the engine. The engine may not start immediately after the battery is reconnected.
If the key battery has died, when the key is held over the ignition switch to start the engine the following warnings will sound:
- Doors other than the driver door open → close:
Warning that one of the passengers is carrying the key outside the vehicle.
- Doors other than the driver door open → close: