2005-2008 Yaris · Service Manual ENGINE

PRECAUTION

Precautions · Vehicles built from Nov 2006


1.PRECAUTIONS WHEN USING INTELLIGENT TESTER
  1. When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals push the switch with your finger until communication between the tester and vehicle begins.

  2. After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).


2.PRECAUTIONS ENTRY AND START FUNCTION
  1. Before starting the engine, firmly depress the clutch pedal until the indicator of the engine switch lights up green.

  2. The power source mode (off, on (ACC), on (IG)) is always stored in the vehicle. After the battery is disconnected and reconnected, the power source condition before battery disconnection will be restored. Be sure to turn the engine switch off before disconnecting the cable from the battery terminal. Be careful if the power source condition before the battery became depleted is not known.

  3. After the battery is disconnected and reconnected, be sure to wait 10 seconds or more before starting the engine. The engine may not start immediately after the battery is reconnected.

  4. If the key battery has died, when the key is held over the engine switch to start the engine the following warnings will sound:

    1. Doors other than the driver door open → close:
      Warning that one of the passengers is carrying the key outside the vehicle.
    These warnings will sound because whether the key is in the cabin or not cannot be determined. They do not indicate system malfunctions.

← SYSTEM DIAGRAM (from Nov 2006)PARTS LOCATION (from Nov 2006) →