2005-2008 Yaris · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Aug 2005


CHECK COMBINATION METER ASSEMBLY

  1. Using the tester probes, touch the terminals from the back of the vehicle wire harness connectors, and measure the voltages and resistance.
    B127205E03
    E126885E01

    Standard: 
    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG2 (D1-1) - Body ground
    B - Body ground
    Ignition switch signal
    Ignition switch OFF → ON
    Below 1 V → 10 to 14 V
    ECUB (D1-2) - Body ground
    L - Body ground
    Battery
    Always
    10 to 14 V
    CANH (D1-20) - Body ground
    G - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    CANL (D1-21) - Body ground
    W - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    ET (D1-24) - Body ground
    BR - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.


CHECK MAIN BODY ECU

  1. Using the tester probes, touch the terminals from the back of the vehicle wire harness connectors, and measure the voltages and resistance.
    B117140E02

    Standard: 
    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    KSW (4D-7) - Body ground
    Y - Body ground
    Key unlock warning switch input
    Key inserted → Key removed from ignition key cylinder
    Below 1 V → 10 to 14V
    GND1 (4E-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    BECU (4B-30) - Body ground
    L - Body ground
    Battery
    Always
    10 to 14 V
    DTCY (4A-21) - Body ground
    R - Body ground
    Driver door courtesy switch input
    Driver door
    closed → open
    10 to 14 V → Below 1 V
    CANL (D33-22) - Body ground
    W - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    CANH (D33-23) - Body ground
    R - Body ground
    CAN communication line
    Ignition switch ON
    Pulse generation
    If the result is not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Jan 2006)DATA LIST / ACTIVE TEST (from Aug 2005) →