B2780 Push Switch / Key Unlock Warning Switch Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
This DTC output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch is ON when the ignition switch is ON.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2780 |
Unlock warning switch ON is not detected when ignition switch is ON |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE OF INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON with a key that cannot start the engine.
On the intelligent tester, enter the following menus: Body/Immobiliser/Data List/Key SW. Read the result.
Transponder key ECU assembly Item
Measurement Item/
Display (Range)
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/
ON or OFF
OFF: No key is in ignition key cylinder
ON: Key is in ignition key cylinder
-
- OK:
- "ON" (key is in ignition key cylinder) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Remove the unlock warning switch.

Measure the resistance.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 - 2
Pushed
Below 1 Ω
1 - 2
Not pushed
10 kΩ or higher
Reinstall the unlock warning switch.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH ASSEMBLY - BODY GROUND) |
Disconnect the D19 unlock warning switch connector.

Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
D19-2 - Body ground
Below 1 Ω
Reconnect the unlock warning switch connector.
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH ASSEMBLY) |
![]() ![]() |
Disconnect the D23 transponder key ECU connector.
Disconnect the D19 unlock warning switch connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
D23-3 (KSW) - D19-1
Below 1 Ω
Reconnect the unlock warning switch and transponder key ECU connectors.
|
|
||||
| OK | ||
| ||

