2005-2008 Yaris · Service Manual TRANSMISSION

P0562 System Voltage

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The battery supplies electricity to the transmission control ECU even when the ignition switch is off. This power allows the transmission control ECU to store data such as the learning value of actuators, DTC history and freeze frame data. If the battery voltage falls below a minimum level, these memories are cleared and the transmission control ECU determines that there is a malfunction in the power supply circuit. If an open or short circuit occurs in the +B circuit while the ignition switch is on (IG), the transmission control ECU stops operating immediately.
DTC No.
DTC Detection Conditions
Trouble Areas
P0562
+B terminal voltage 7.0 V or less for 0.5 seconds or more
(1 trip detection logic)
  1. Open or short in power source circuit
  2. Transmission control ECU

WIRING DIAGRAM

C127405E01

INSPECTION PROCEDURE


1. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY
C112717E03
  1. Disconnect the transmission control ECU connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester Connections
    Specified Conditions
    GND (D79-6) - Body ground
    Below 1 Ω
    PGND (A37-8) - Body ground
    Below 1 Ω

  1. Measure the voltage between the terminals of the transmission control ECU connectors.

    Standard voltage:
    Tester Connections
    Specified Conditions
    +B (D79-1) - GND (D79-6)
    10 to 14 V

  1. Reconnect the transmission control ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSMISSION CONTROL ECU - BATTERY, BODY GROUND)
OK

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY


← P0500 Vehicle Speed Sensor "A" (from Nov 2005)P0603 Internal Control Module Keep Alive Memory (KAM) Error (+ P0613) (from Nov 2005) →