ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT SHIFT LOCK SOLENOID |
![]() ![]() |
Disconnect the indicator light wire connector.
Using an ohmmeter, measure the resistance between terminals 2 and 6.
- Standard Resistance:
- 30 to 35 Ω at 20°C (68°F)
Check the solenoid operating sound when applying battery voltage across terminals 2 and 6.

If the solenoid does not operate, replace the shift lever assembly.
Connect the indicator light wire connector.
| INSPECT TRANSMISSION SHIFT MAIN SWITCH |
![]() ![]() |
Disconnect the indicator light wire connector.
Move the shift lever to the M position.
Using an ohmmeter, measure the resistance according to the value in the table below.
- Standard Resistance:
Shift position
Terminals
Specified condition
M
4 - 8
Below 1 Ω
Move the shift lever to the E position.

Using an ohmmeter, measure the resistance according to the value in the table below.
- Standard Resistance:
Shift position
Terminals
Specified condition
E
4 - 8
10 kΩ or higher
Connect the indicator light wire connector.
| INSPECT SHIFT LEVER POSITION SENSOR |
![]() ![]() |
Disconnect the shift lever position sensor connector.
Using an ohmmeter, measure the resistance according to the values in the table below.
- Standard Resistance:
Shift position
Terminals
Specified condition
R
4 - 9 - 10 - 13
Below 1 Ω
N
4 - 2 - 10 - 6
Below 1 Ω
E, M
4 - 2 - 3 - 13
Below 1 Ω
+
11 - 5
Below 1 Ω
M
11 - 5 - 12
10 kΩ or higher
-
11 - 12
Below 1 Ω
Connect the shift lever position sensor connector.



