2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT HEATER SWITCH ASSEMBLY

I102351E01
  1. Check the heater switch resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the values in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (IN) - 4 (IG)
      Heater switch OFF
      10 kΩ or higher
      1 (IN) - 4 (IG)
      Heater switch ON
      Below 1 Ω

      If the result is not as specified, replace the heater switch.

  1. Check the indicator operation.

    1. Connect the positive (+) lead from the battery to terminal 4 (IG) and the negative (-) lead to terminal 5 (E).

    2. Push the switch in and check that the indicator lights up.

      Standard:
      Indicator lights up

      If the result is not as specified, replace the heater switch.

  1. Check the illumination operation.

    1. Connect the positive (+) lead from the battery to terminal 3 (ILL+) and the negative (-) lead to terminal 2 (ILL-), then check that the illumination illuminates.

      Standard:
      Illumination illuminates

      If the result is not as specified, replace the heater switch.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →