2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL TRANSMISSION REVOLUTION SENSOR

C112888
  1. Install a new O-ring onto the transmission revolution sensor.

  1. Install the transmission revolution sensor with the bolt.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. C112889
    Install the transmission case protector with the bolt.

    Torque:
    18 N*m{ 185 kgf*cm , 13 ft.*lbf }

  1. C112890
    Connect the revolution sensor connector.


2. ADD TRANSAXLE OIL

3. INSPECT AND ADJUST TRANSAXLE OIL

D025304E03
  1. Stop the vehicle on a level place.

  1. Remove the filler plug and gasket.

  1. Check that the oil surface is within 5 mm (0.20 in.) of the lowest position of the filler plug opening.

    NOTICE:
    1. An excessively large or small amount of oil may cause problems.
    2. After replacing the oil, drive the vehicle and check the oil level again.

  1. When the oil level is low, check for oil leakage.

  1. Install the filler plug and a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →