2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

C129940
  1. Using SST, install the back-up light switch with a new gasket onto the transaxle case.

    SST
    09817-16011  

    Torque:
    40 N*m{ 410 kgf*cm , 30 ft.*lbf }

  1. C129937
    Connect the back-up light switch connector.

  1. Install the wire harness bracket with the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Connect the wire harness clamp.


2. INSTALL NO. 1 AIR TUBE

  1. C129934
    Install the No. 1 air tube with the 2 bolts.

    Torque:
    20 N*m{ 199 kgf*cm , 14 ft.*lbf }

  1. Install the wire harness bracket with the bolt.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

  1. Connect the No. 1 air hose with the clamp.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


3. INSTALL NO. 2 AIR HOSE

  1. C129935
    Install the No. 2 air hose with the 2 clamps.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


4. INSTALL BATTERY CARRIER

  1. C106370
    Install the battery carrier with the 5 bolts.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }


5. INSTALL BATTERY TRAY

6. INSTALL BATTERY

7. INSTALL BATTERY HOLD DOWN CLAMP

8. INSTALL AIR CLEANER ASSEMBLY

  1. A125745
    Install the air cleaner case sub-assembly with air cleaner inlet with the 3 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


9. INSTALL NO. 1 AIR CLEANER HOSE

  1. C127625
    Connect the No. 1 air cleaner hose with the 2 clips.

  1. Connect the 2 fuel hoses.

  1. Connect the No. 1 air cleaner hose with the clamp.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →