2005-2008 Yaris · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE AIR CLEANER INLET NO.1 (for 2SZ-FE)

C127624
  1. Remove the air cleaner inlet No. 1.


3. REMOVE BATTERY HOLD DOWN CLAMP

4. REMOVE BATTERY

5. REMOVE BATTERY TRAY

6. REMOVE BATTERY CARRIER (for 1KR-FE)

C106985
  1. Remove the 4 bolts and the battery carrier.


7. REMOVE BATTERY CARRIER (for 2SZ-FE)

C106370
  1. Remove the 5 bolts and the battery carrier.


8. SUPPORT MULTI-MODE MANUAL TRANSAXLE ASSEMBLY

9. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR (for 1KR-FE)

  1. C108066
    Remove the bolt and nut, then separate the engine mounting insulator LH.

  1. Remove the 4 bolts and the engine mounting insulator LH.


10. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR (for 2SZ-FE)

C121115
  1. Remove the bolt and nut, then separate the engine mounting insulator LH.

  1. Remove the 5 bolts and the engine mounting insulator LH.


11. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET (for 1KR-FE)

C121113
  1. Remove the 4 bolts and the engine mounting bracket LH.


12. REMOVE TRANSVERSE ENGINE ENGINE MOUNTING BRACKET (for 2SZ-FE)

C121114
  1. Remove the 4 bolts and the engine mounting bracket LH.


13. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY

C112893
  1. Disconnect the back-up light switch connector.

  1. Separate the back-up light switch wire harness from the 2 clamps.

  1. C112894E01
    Using SST, remove the back-up light switch and gasket from the transaxle case.
    SST
    09817-16011  

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →