DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2005
| DATA LIST |
- HINT:
- Using the intelligent tester DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to shorten labor time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
On the intelligent tester, enter the following menu items: Body/Immobiliser/Data List.
Transponder key ECU assembly Item
Measurement Item/
Display (Range)
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/
ON or OFF
OFF: No key is in ignition key cylinder
ON: Key is in ignition key cylinder
-
IG SW
Ignition switch signal/ ON or OFF
OFF: Ignition switch OFF or ACC
ON: Ignition switch ON
-
Immobiliser
Immobiliser system status/
SET or UNSET
UNSET: Ignition switch ON
SET: Without key
-
Permit (Start)
Start control system starting control / OK or NG
OK: Start control system starting is permitted
NG: Start control system starting is not permitted
-
Response
Transponder chip data/
NG or OK
NG: Data error
OK: Data OK
-
Frame Error
Transponder chip data/
NG or OK
NG: Data error
OK: Data OK
-
Different Serial Number
Transponder chip data/
NG or OK
NG: Data error
OK: Data OK
-
Different Encrypt Code
Transponder chip data/
NG or OK
NG: Data error
OK: Data OK
-
Abnormal Status
Transponder chip data/
NG or OK
NG: Data error
OK: Data OK
-
Bcc Malfunction
Transponder chip signal/
NG or OK
NG: Incorrect data sending
OK: Correct data sending
-
Sub Key
Sub-key code signal/
NOMATCH or MATCH
NOMATCH: Unmatched sub-key code is sent
MATCH: Sub-key code is sent
-
Master Key
Master key code signal/
NOMATCH or MATCH
NOMATCH: Unmatched master key code is sent
MATCH: Master key code is sent
-
Transponda S-Code
Number of registered sub-key/
min. 0, max. 15
Number of registered sub-keys
-
Transponda M-Code
Number of registered master key/
min. 0, max. 15
Number of registered master keys
-
Reg Code Space Full
Memory space for key
codes registration/
NOT FUL or FULL
NOT FUL: Possible to register more key codes
FULL: Cannot register any more key codes
-
+B
+B judgment /
NORMAL or BREAK
NORMAL: Battery supply is normal
BREAK: Battery supply is malfunctioning
-
Antenna Coil Status
Transponder key coil condition/
NORMAL or FAIL
NORMAL: Transponder key coil is normal
FAIL: Transponder key coil is malfunctioning
-
| ACTIVE TEST |
- HINT:
- Performing the intelligent tester ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
On the intelligent tester, enter the following menus: Body/Immobiliser/Active Test.
Transponder key ECU assembly Item
Normal Condition
Diagnostic Note
Security Indic
Turn security indicator ON/OFF
-