REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO.1 AIR CLEANER HOSE |
Loosen the hose clamp No. 1 and disconnect the air cleaner hose.

Disconnect the 2 fuel hoses.
Loosen the 2 clips and disconnect the No. 1 air cleaner hose.
| 3. REMOVE AIR CLEANER ASSEMBLY |
Remove the 3 bolts, then remove the air cleaner case with air the cleaner inlet.

| 4. REMOVE CLUTCH STROKE SENSOR |
Disconnect the clutch stroke sensor connector.

- NOTICE:
- Do not forcibly pull the connector as this may damage the wire harness.
Remove the 2 screws and the stroke sensor from the clutch actuator.
Remove the O-ring.
