2005-2008 Yaris · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE REAR GENERATOR END COVER

A127363
  1. Using a torx socket wrench(T25), remove the 2 bolts from the rear generator end cover.

  1. Remove the screw, then remove the rear generator end cover.


2. REMOVE REGULATOR SUB-ASSEMBLY GENERATOR WITH BRUSH

A127364
  1. Remove the 3 screws, then remove the regulator sub-assembly generator with brush.


3. REMOVE STATOR SUB-ASSEMBLY GENERATOR WITH RECTIFIER

A127365
  1. Remove the 4 bolts.

  1. A127366
    Using a screwdriver, pry out the stator sub-assembly generator with rectifier.


4. REMOVE BEARING SET GENERATOR

A127367

5. REMOVE PULLEY SET GENERATOR
  1. Clamp the swivel arm in a vise.

    NOTICE:
    Do not clamp the generator rotor in a vise.

  1. A127369E01
    Using a socket 24 AF and an 8 mm bi-hexagon wrench, remove the nut and spring washer, then detach the pulley.


6. REMOVE GENERATOR ROTOR ASSEMBLY

A127368
  1. Using a press, press out the generator rotor assembly and spacer ring.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →