P0703 Brake Switch "B" Circuit
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
When the brake pedal is depressed, stop light switch signal STP turns on and stop light switch signal ST1- turns off. The transmission control ECU detects the brake pedal condition whether the pedal is depressed or released from those signal input. If the signal conditions, STP and ST1-, do not match the standard condition, the transmission control ECU interprets this as a malfunction in the stop light switch circuit and sets the DTC.| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0703 |
Following conditions detected simultaneously for 1.0 second or more (1 trip detection logic)
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Multi-Mode M/T / Data List / Brake Switch Signal1, Brake Switch Signal2 and STP Switch Signal.
Read the value, and check the stop light operation.
Items
[Abbreviation]
Measurement Items: Display
Normal Conditions
Diagnostic Notes
Brake Switch Signal1
[Brake SW Sig1]
Brake switch signal (STP):
Open (OFF) or Gnd (ON)
Gnd: Brake pedal depressed
Open: Brake pedal released
STP terminal signal of transmission control ECU
Brake Switch Signal2
[Brake SW Sig2]
Brake switch signal (ST1-):
Open (OFF) or Gnd (ON)
Open: Brake pedal depressed
Gnd: Brake pedal released
ST1- terminal signal of transmission control ECU
- OK:
- The normal conditions listed above are shown on the tester when the brake pedal is operated.
|
|
||||
| NG | |
| 2. INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() ![]() |
Disconnect the stop light switch assembly connector.
Check the resistance.
- Standard resistance:
Switch Positions
Tester Connections
Specified Conditions
Switch pin released
1-2
Below 1 Ω
Switch pin released
3-4
10 kΩ or higher
Switch pin pushed in
1-2
10 kΩ or higher
Switch pin pushed in
3-4
Below 1 Ω
Reconnect the stop light switch assembly connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY) |
![]() ![]() |
Disconnect the stop light switch assembly connector.
Turn the ignition switch on (IG).
Measure the voltage between the terminals of the stop light switch assembly connector.
- Standard voltage:
Tester Connections
Specified Conditions
A13-2 - Body ground
10 to 14 V
A13-3 - Body ground
10 to 14 V
Reconnect the stop light switch assembly connector.
|
|
||||
| OK | |
| 4. INSPECT TRANSMISSION CONTROL ECU ASSEMBLY |
![]() ![]() |
Disconnect the transmission control ECU connector.
Turn the ignition switch on (IG).
Measure the voltage between the terminals of the transmission control ECU connector.
- Standard voltage:
Pedal Conditions
Tester Connections
Specified Conditions
Depressed
STP (D79-34) - Body
ground
10 to 14 V
Released
STP (D79-34) - Body
ground
Below 1 V
Depressed
ST1- (D79-35) - Body
ground
Below 1 V
Released
ST1- (D79-35) - Body
ground
10 to 14 V
Reconnect the transmission control ECU connector.
|
|
||||
| OK | ||
| ||



