2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF and install it into the transmission wire.

  1. D025196
    Pass the transmission wire through the transaxle.

  1. C057520
    Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

C059784
  1. Coat new governor apply gasket No. 1 with ATF and install it onto the transaxle case.

  1. C057516E02
    Connect the connecting rod to the manual valve lever, and install the valve body.

  1. D025197E01
    Provisionally install the valve body with the 14 bolts.

    Bolt length:
    Bolt A:
    20 mm (0.79 in.)
    Bolt B:
    28 mm (1.10 in.)
    Bolt C:
    49 mm (1.93 in.)
    Bolt D:
    36 mm (1.42 in.)
    Bolt E:
    40 mm (1.57 in.)

  1. Tighten the 14 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. D025198E01
    Connect the 5 shift solenoid valve connectors and ATF temperature sensor.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

C057509
  1. Install a new oil strainer gasket onto the oil strainer.

  1. C057507
    Install the oil strainer with the 3 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

C057519E01
  1. Install the 2 magnets onto the oil pan, as shown in the illustration.

  1. C057506
    Install the oil pan and a new gasket with the 18 bolts.

    Torque:
    7.0 N*m{ 70 kgf*cm , 61 in.*lbf }


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


6. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
T-IV

Capacity:
2.0 liters (2.1 US qts, 1.7 lmp. qts)


7. INSPECT AUTOMATIC TRANSAXLE FLUID

D025120E03

HINT:
Drive the vehicle until the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80 °C (158 to 176 °F)

  1. Park the vehicle on a level surface and engage the parking brake.

  1. With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to the P position.

  1. Pull out the oil level gauge and wipe it clean.

  1. Push it fully back into the pipe.

  1. Pull it out and check that the fluid level is within the HOT range.
    If there is any leakage, repair or replace O-rings, FIPGs, oil seals, plugs or other parts.


8. CHECK FOR AUTOMATIC TRANSAXLE FLUID LEAKAGE

9. INSTALL ENGINE UNDER COVER LH
← INSPECTION (from Aug 2005)COMPONENTS (from Aug 2005) →