2005-2008 Yaris · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. REMOVE BATTERY
  1. Disconnect the cable from the battery terminal.

  1. Loosen the nut and remove the battery clamp.

  1. Remove the battery.


2. REMOVE BATTERY TRAY

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Remove the shift lever knob sub-assembly from the shift lever.


4. REMOVE CONSOLE BOX REAR COVER

C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.


5. REMOVE CONSOLE BOX CARPET

C109008
  1. Remove the console box carpet.


6. REMOVE CONSOLE BOX ASSEMBLY REAR

C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.


7. SEPARATE OXYGEN SENSOR CONNECTOR

C117113
  1. Pull back the floor carpet and disconnect the oxygen sensor connector.

  1. Remove the grommet and put the oxygen sensor connector outside of the vehicle.


8. REMOVE AIR CLEANER ASSEMBLY

A117355
  1. Separate the intake air flow meter connector and wire harness clamp.

  1. Separate the fuel vapor feed hose and fuel vapor feed hose No. 1 from the vacuum switching valve assembly.

  1. Separate the vacuum switching valve connector and wire harness clamp.

  1. Separate the ventilation hose from the air cleaner hose.

  1. Release the air cleaner cap sub-assembly with air cleaner hose No. 1.

  1. Loosen the air cleaner hose clamp on the throttle body side and remove the air cleaner cap and air cleaner hose.

  1. Remove the air cleaner element.

  1. A104895
    Separate the wire harness clamp from the air cleaner case.

  1. Remove the 2 bolts and remove the air cleaner case with air cleaner inlet No. 1.


9. REMOVE AIR CLEANER BRACKET

A117308
  1. Separate the wire harness clamp from the air cleaner bracket.

  1. Remove the 2 bolts and remove the air cleaner bracket.


10. REMOVE EXHAUST PIPE ASSEMBLY FRONT
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove exhaust pipe support No. 4 and exhaust front pipe assembly.

    A119126

  1. Remove the 2 exhaust pipe gaskets.


11. REMOVE FRONT FLOOR HEAT INSULATOR NO.1

C117116E01
  1. Remove the 2 bolts and the nut and remove floor heat insulator No. 1.


12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

C117115
  1. Disconnect the control cable from the shift lever.

  1. C117114E01
    Turn the nut and separate the control cable from the shift lever retainer.

  1. Disconnect the control cable from the control cable support.

  1. C107765
    Remove the nut and disconnect the control cable from the control shaft lever.

  1. Remove the clip and separate the control cable from the control cable bracket.

  1. C117117
    Remove the 3 nuts and remove the control cable.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →