REASSEMBLY
Removal / installation · Vehicles built from Aug 2005
| 1.
INSTALL CLUTCH DRUM OIL SEAL RING |
 |
Coat 2 new clutch drum oil seal rings with ATF, and install them onto the stator shaft.
| 2.
INSTALL FRONT OIL PUMP OIL SEAL |
 |
Using SST, install the front oil pump oil seal into the oil pump body.
- SST
- 09950-60010
(09951-00550)
09950-70010
(09951-07100)
- Oil seal drive in depth:
- -0.15 to 0.15 mm (-0.006 to 0.006 in.)
| 3.
INSTALL FRONT OIL PUMP DRIVEN GEAR |
 |
Coat the front oil pump driven gear with ATF, and install it into the oil pump body with the marked side facing upward.
| 4.
INSTALL FRONT OIL PUMP DRIVE GEAR |
 |
Coat the front oil pump drive gear with ATF, and install it into the oil pump body with the marked side facing upward.
| 5.
INSTALL STATOR SHAFT ASSEMBLY |
 |
Using "Torx" socket wrench T30, install the stator shaft assembly with 10 "Torx" screws.
-
Torque:
- 9.8 N*m{
100 kgf*cm
, 7 ft.*lbf
}
| 6.
INSPECT OIL PUMP ASSEMBLY |
 |
Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.
- NOTICE:
- Do not damage the oil seal lip.
| 7.
INSTALL FRONT OIL PUMP BODY O-RING |
 |
Coat a new front oil pump body O-ring with ATF, and install it onto the oil pump.