INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT SHIFT SOLENOID VALVE S1 |
![]() ![]() |
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (S1) - Solenoid Body (S1)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check the operation of the valve.
- NOTICE:
- While using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
- OK:
- The solenoid makes an operating sound.
| INSPECT SHIFT SOLENOID VALVE S2 |
![]() ![]() |
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (S2) - Solenoid Body (S2)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check the operation of the valve.
- NOTICE:
- While using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
- OK:
- The solenoid makes an operating sound.
| INSPECT SHIFT SOLENOID VALVE ST |
![]() ![]() |
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (ST) - Solenoid Body (ST)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check the operation of the valve.
- NOTICE:
- While using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
- OK:
- The solenoid makes an operating sound.
| INSPECT SHIFT SOLENOID VALVE SLT |
![]() ![]() |
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
1 - 2
5.0 to 5.6 Ω at 20°C (68°F)
Connect the positive (+) battery lead with a 21 W bulb to terminal 2 and the negative (-) battery lead to terminal 1 of the solenoid valve connector, and check the operation of the valve.
- NOTICE:
- While using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
- OK:
- The solenoid makes an operating sound.
| INSPECT SHIFT SOLENOID VALVE SL |
![]() ![]() |
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
Solenoid Connector (SL) - Solenoid Body (SL)
11 to 15 Ω at 20°C (68°F)
Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check the operation of the valve.
- NOTICE:
- While using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
- OK:
- The solenoid makes an operating sound.






