REASSEMBLY
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL FRONT DIFFERENTIAL SIDE GEAR |
![]() ![]() |
Coat the sliding and rotating surfaces of the front differential side gear with gear oil.
Install the 2 front differential side gear thrust washers No. 1 onto the 2 front differential side gears.
Install the 2 front differential side gears, 2 front differential pinions and 2 front differential pinion thrust washers onto the front differential case.
- HINT:
- Revolving the front differential side gear, install the 2 front differential pinions and 2 front differential pinion thrust washers.
| 2. INSTALL FRONT DIFFERENTIAL PINION SHAFT NO.1 |
![]() ![]() |
Coat front differential pinion shaft No. 1 with MP grease.
Install front differential pinion shaft No. 1 onto the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.
| 3. ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() ![]() |
Fix the front differential pinion to the front differential case side. Using a dial indicator, measure the front differential side gear backlash.
- Standard backlash:
- 0.05 to 0.20 mm (0.0020 to 0.0079 in.)
- Thrust washer thickness:
Parts No.
Thickness mm (in.)
41361 - 22140
0.95 (0.0374 in.)
41361 - 22020
1.00 (0.0394 in.)
41361 - 22150
1.05 (0.0413 in.)
41361 - 22030
1.10 (0.0433 in.)
41361 - 22160
1.15 (0.0452 in.)
41361 - 22040
1.20 (0.0472 in.)
- HINT:
- Because the thrust washer does not have any marks for distinction, measure the thickness with a micrometer to select a proper thrust washer.
- Select washers of the same thickness for both the right and left.
- Because the thrust washer does not have any marks for distinction, measure the thickness with a micrometer to select a proper thrust washer.
| 4. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() ![]() |
Using a pin punch (φ3 mm) and a hammer, install the front differential pinion shaft straight pin onto the front differential case.
Using a chisel and a hammer, stake the front differential case hole.

| 5. INSTALL FRONT DIFFERENTIAL RING GEAR |
![]() ![]() |
Clean the contact surfaces of the front differential case and ring gear.
Using a heater, heat the front differential ring gear to 90 to 110°C (194.0 to 230.0°F).
After the moisture on the ring gear has completely evaporated, quickly install the ring gear onto the differential case.
Aligning the 2 matchmarks, quickly install the front differential ring gear onto the front differential case.

Install the 8 bolts.
- Torque:
- 77 N*m{ 790 kgf*cm , 57 ft.*lbf }
| 6. INSTALL SPEEDOMETER DRIVE GEAR |
![]() ![]() |
Install the speedometer drive gear onto the front differential case.






