REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL SELECT SPRING NO.1 SEAT SHAFT SNAP RING |
Coat the shift and select lever shaft with MP grease, and install a snap ring onto the shift and select lever shaft using a brass bar and a hammer.

| 2. INSTALL SELECT INNER LEVER |
![]() ![]() |
Coat select spring seat No. 1 with MP grease.
Using a pin punch (φ5 mm) and a hammer, install select spring seat No. 1, select return compression spring No. 1, the select inner lever and select inner lever slotted spring pin onto the shift and select lever.
- Drive in depth:
- 3.0 to 4.0 mm (0.1181 to 0.1575 in)
| 3. INSTALL SHIFT LEVER INNER NO.1 |
![]() ![]() |
Coat the shift inter lock plate and shift lever inner No. 1 with MP grease.
Using a pin punch (φ5 mm) and a hammer, install the shift inter lock plate, shift lever inner No. 1 and shift inner lever slotted spring pin onto the shift and select lever shaft.
- Drive in depth:
- -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
| 4. INSTALL SHIFT LEVER INNER NO.2 |
![]() ![]() |
Coat shift lever inner No. 2 with MP grease.
Using a pin punch (φ5 mm) and a hammer, install shift lever inner No. 2 and shift inner lever slotted spring pin onto the shift and select lever shaft.
- Drive in depth:
- 1.0 to 2.0 mm (0.0394 to 0.0787 in.)
| 5. INSTALL SELECT SPRING SEAT NO.2 |
![]() ![]() |
Coat select spring seat No. 2 with MP grease.
Install select spring seat No. 2 and select return compression spring No. 2. Using pliers, install a new select spring seat No. 2 E-ring onto the shift and select lever shaft.




