ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT FRONT NO. 2 SPEAKER |
- HINT:
- Remove interior parts so that the front No. 2 speaker can be seen.
Check the speaker installation.
- OK:
- The speaker is securely installed.
Visually check the speaker.
- OK:
- The cone paper of the speaker is not torn.
Check the speaker resistance.

Disconnect the front No. 2 speaker connector.
Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
1(TWR-) - 2(-)
Below 1 Ω
3(TWRH) - 4(+)
Below 1 Ω
