2005-2008 Yaris · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. TEMPORARILY TIGHTEN FRONT SUSPENSION LOWER ARM

C107515
  1. Provisionally tighten the lower arm with the 2 bolts.

  1. C107513
    Install the lower arm onto the steering knuckle with a new castle nut.

    Torque:
    98 N*m{ 1,000 kgf*cm , 72 ft.*lbf }

    NOTICE:
    If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.

  1. Install a new clip.


2. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


3. STABILIZE SUSPENSION
  1. Lower the vehicle from the jack.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


4. FULLY TIGHTEN FRONT SUSPENSION LOWER ARM

C107515E01
  1. Fully tighten the 2 bolts.

    Torque:
    Bolt A:
    137 N*m{ 1,397 kgf*cm , 101 ft.*lbf }
    Bolt B:
    160 N*m{ 1,631 kgf*cm , 118 ft.*lbf }


5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSPECTION (from Nov 2005)COMPONENTS (from Jan 2006) →