2005-2008 Yaris · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jan 2006


1. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

  1. B138595
    Hold the front edge of the rear seat cushion cover pad and lift it up, as shown in the illustration, to disengage the 2 hooks.

    NOTICE:
    Hold the area around the hooks so as to avoid deforming the rear seat cushion frame.

  1. Pass the rear seat inner belt through the slit in the rear seat cushion cover pad, disengage the hook between the rear seat cushion cover pad and the rear seatback, and remove the rear seat cushion cover pad.


2. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

  1. B138450E01
    Remove the rear seat outer belt from the rear seat shoulder belt guide.

    HINT:
    Use the same procedure for both sides.

  1. for 3 Point Type Rear Center Seat belt:

    1. Remove the rear center seat outer belt from the rear center seat shoulder belt guide.

  1. B134981
    Remove the 3 bolts.

  1. Disengage the 3 hooks and remove the rear seatback.


3. REMOVE REAR WHEEL

4. REMOVE REAR SHOCK ABSORBER CAP

5. REMOVE REAR SHOCK ABSORBER
  1. Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.

  1. C132100
    Remove the 2 nuts while keeping the piston rod from rotating.

  1. Remove the cushion retainer and suspension support.

  1. C106031
    Remove the bolt while keeping the nut from rotating and remove the shock absorber.

    NOTICE:
    Remove the nut fromthe bolt side because the one on the lower side is a jam nut.


6. REMOVE REAR SUSPENSION SUPPORT STOPPER

7. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY
← COMPONENTS (from Jan 2006)INSPECTION (from Jan 2006) →