TEST MODE PROCEDURE
Troubleshooting · Vehicles built from Jan 2006
- NOTICE:
- The torque sensor zero point calibration is performed automatically when the test mode inspection is conducted after the power steering ECU has been replaced with a new one.
- HINT:
- Speed sensor signals can be checked easily in test mode.
- Test mode code C1571/71 is stored during the transition to test mode. This code does not indicate a malfunction since the code will be cleared when the ECU determines that the sensor is normal.
- The test mode code is cleared simultaneously when test mode is terminated.
- Speed sensor signals can be checked easily in test mode.
| TEST MODE START-UP |
When using an intelligent tester;
Connect the intelligent tester to the DLC3.
Turn the ignition switch on and enter test mode by following the instructions on the tester screen.
When not using an intelligent tester;

Turn the ignition switch off and connect terminals 12 (TS) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch on.
- NOTICE:
- Be sure to connect the correct terminals of the connector, otherwise a malfunction may occur.
- If the torque sensor zero point calibration has not been performed, the torque sensor zero point calibration is performed automatically when test mode is entered.
- Be sure to connect the correct terminals of the connector, otherwise a malfunction may occur.
| CHECK TEST MODE DISPLAY |
The P/S warning light blinks as shown on the left when test mode is entered.

- NOTICE:
- If the torque sensor zero point calibration has not been performed, the P/S warning comes on until the torque sensor zero point calibration is completed, and shows the test mode blink pattern after the torque sensor zero point calibration is completed.
| CHECK VEHICLE SPEED SIGNAL (W/O ABS) |
Drive the vehicle until the vehicle speed reaches 10 Km/h (6 mph) or more.


| READ TEST MODE CODE |
When using an intelligent tester;
Check the DTCs in test mode.
- NOTICE:
- Test mode code is cleared when test mode is terminated.
When not using an intelligent tester;

Turn the ignition switch off.
Connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Read the number of times that the P/S warning light on the combination meter blinks.

- To indicate the normal code, the P/S warning light comes on for 0.25 seconds at intervals of 0.25 seconds (2Hz blink).
- When outputting a DTC, the P/S warning light displays it at intervals of 4 seconds. When outputting two or more DTCs, the P/S warning light displays each DTC at intervals 2.5 seconds, and repeats from the first one 4 seconds after indicating the last one.
- If two or more malfunctions are detected at the same time, DTCs are displayed in ascending numerical order.
- To indicate the normal code, the P/S warning light comes on for 0.25 seconds at intervals of 0.25 seconds (2Hz blink).
| END OF TEST MODE |
When using an intelligent tester;
Return to normal mode by following the instructions on the tester screen.
Turn the ignition switch off and disconnect the tester.
When not using an intelligent tester;
Turn the ignition switch off and disconnect terminals 13 (TC) and 4 (CG), and terminals 12 (TS) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch on.
| Code |
Detection Item |
Conditions to clear code |
Trouble areas |
| C1571/71 |
Vehicle speed check |
Vehicle speed 10 Km/h (6 mph) or more |
If code cannot be cleared, any of following areas may malfunction.
|