2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

C125987E01
  1. Install the lock nut onto the push rod.

  1. Install the push rod clevis.

  1. Tighten the lock nut and check the dimension A is same as the dimension A that has been measured.


2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

C115307
  1. Install the clutch master cylinder with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }


3. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C115313
  1. Using SST, connect the flexible hose tube.

    SST
    09023-00101  

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }


4. INSTALL CLUTCH RESERVOIR TUBE
  1. Connect the clutch reservoir tube with the clip to the clutch master cylinder assembly.


5. INSTALL BRAKE BOOSTER ASSEMBLY
(Click here)

6. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.

  1. C115306E01
    Check that the pedal height is correct.

    Pedal height from floor:
    118.1 to 128.1 mm (4.650 to 5.043 in.) 1KR-FE/2NZ-FE

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }


7. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1

  1. B114572
    Engage the 3 claws and install the instrument panel under cover.

  1. Tighten the 2 screws.

← REMOVAL (from Aug 2005)COMPONENTS (from Aug 2005) →