INSTALLATION
Removal / installation · Vehicles built from Aug 2005
| 1. INSTALL CLUTCH DISC ASSEMBLY |
![]() ![]() |
Insert SST into the clutch disc assembly, then insert them both into the flywheel sub-assembly.
- SST
- 09301-00110
- NOTICE:
- Insert clutch disc assembly in the correct direction.
| 2. INSTALL CLUTCH COVER ASSEMBLY |
![]() ![]() |
Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.
- Torque:
- 19 N*m{ 195 kgf*cm , 14 ft.*lbf }
- HINT:
- Following the order in the illustration, tighten the bolts evenly one at a time.
- Move SST up and down, right and left lightly after checking that the disc is in the center, and tighten the bolts.
- Following the order in the illustration, tighten the bolts evenly one at a time.
- SST
- 09301-00110
| 3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() ![]() |
Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.
- Maximum non-alignment:
- 0.5 mm (0.020 in.)
If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.

- SST
- 09333-00013
| 4. INSTALL RELEASE FORK SUPPORT |
Install the release fork support onto the transaxle assembly.
- Torque:
- 37 N*m{ 375 kgf*cm , 27 ft.*lbf }
| 5. INSTALL CLUTCH RELEASE FORK BOOT |
| 6. INSTALL RELEASE BEARING HUB CLIP |
| 7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() ![]() |
Apply release hub grease to the contact surfaces of the release fork and release bearing assembly, release fork and push rod, and release fork and fork support.
- Sealant:
- Part No. 08887-01806, RELEASE HUB GREASE or the equivalent
Install the release fork onto the release bearing assembly.
| 8. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
Apply clutch spline grease to the input shaft spline.
- Sealant:
- Part No. 08887-01706, CLUTCH SPLINE GREASE or the equivalent
Install the clutch release bearing with release fork onto the transaxle assembly.
- NOTICE:
- After the installation, move the fork forward and backward to check that the release bearing slides smoothly.
| 9. INSTALL MANUAL TRANSAXLE ASSEMBLY |




