2005-2008 Yaris · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL CLUTCH START SWITCH ASSEMBLY

C116855
  1. Install the clutch start switch with the nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }

    NOTICE:
    Insert the protrusion of the clutch start switch into the hole in the clutch pedal support.

  1. Connect the clutch start switch connector.


2. INSPECT CLUTCH START SWITCH ASSEMBLY

C115311
  1. Check that the engine does not start when the clutch pedal is released.

  1. Check that the engine starts when the clutch pedal is fully depressed.
    If necessary, replace the clutch start switch assembly.

← INSPECTION (from Aug 2005)PROBLEM SYMPTOMS TABLE (from Nov 2005) →