INSTALLATION
Removal / installation · Vehicles built from Jan 2006
| 1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY |
![]() ![]() |
Install the shift lever with the 4 bolts.
- Torque:
- 12 N*m{ 122 kgf*cm , 8.9 ft.*lbf }
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() ![]() |
Install the control shift cable onto the shift lever retainer.
- NOTICE:
- Install the cable with the protruding portion of the cable outer facing upward.
- After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.
- Install the cable with the protruding portion of the cable outer facing upward.
Connect the control shift cable to the shift lever.
Install the control select cable onto the shift lever retainer.

- NOTICE:
- Install the cable with the protruding portion of the cable outer facing upward.
- After installing, check that the lock of the cable outer is protruding beyond portion A, as shown in the illustration.
- Install the cable with the protruding portion of the cable outer facing upward.
Connect the control select cable to the shift lever.

- NOTICE:
- Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.
- Insert the clip in the direction shown in the illustration.
- Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.
Adjust the length of the control select cable.

Slide the adjuster case cover in the direction shown in the illustration (Illustration A).
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Press the lock piece into the adjuster case and lock it (Illustration B).
Slide the cover in the direction shown in the illustration (Illustration C).
- NOTICE:
- Slide the cover past the protrusion of the lock piece (Illustration D).
| 3. INSTALL REAR CONSOLE BOX ASSEMBLY |
Engage the 4 claws and install the rear console box.

Install the 2 bolts and 2 screws.
Connect the clamp.
| 4. INSTALL CONSOLE BOX CARPET |
Install the console box carpet.

| 5. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
Connect the connector.

Engage the 3 clips and 3 claws and install the console upper rear panel.
| 6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
Engage the 5 clips and the claw and install the upper console panel.

| 7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
Install the shift lever knob.

| 8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() ![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.



