REMOVAL
Removal / installation · Vehicles built from Jan 2006
| 1. DRAIN BRAKE FLUID |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 2. REMOVE BATTERY |
| 3. REMOVE BATTERY TRAY |
| 4. REMOVE BATTERY CARRIER |
| 5. REMOVE BRAKE ACTUATOR (for LHD) |
![]() ![]() |
Remove the clip and disconnect the wire harness.
Move the lock lever in the direction indicated by the arrow to release the lock and disconnect the brake actuator connector from the actuator.
Using SST, separate the brake tube from the front flexible hose.

- SST
- 09023-00100
Using SST, separate the 2 brake tubes from the brake tube No. 1 way.

- SST
- 09023-00100
Using SST, separate the 2 brake tubes from the brake master cylinder.

- SST
- 09023-00100
Using SST, separate the 6 brake tubes from the brake actuator.

- SST
- 09023-00100
Use tags or labels to identify the place to reconnect each brake tube.

Disconnect the brake tube clamp.

Remove the 3 bolts and the actuator with bracket.

| 6. REMOVE BRAKE ACTUATOR (for RHD) |
![]() ![]() |
Move the lock lever in the direction indicated by the arrow to release the lock and disconnect the brake actuator connector from the actuator.
Using SST, separate the 6 brake tubes from the brake actuator.

- SST
- 09023-00100
Use tags or labels to identify the place to reconnect each brake tube.

Remove the 3 bolts and the actuator with bracket.

| 7. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY |
![]() ![]() |
Remove the 2 nuts and the bracket.



