2005-2008 Yaris · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL FRONT SPEED SENSOR

C121848
  1. Install the speed sensor onto the steering knuckle with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Check that the speed sensor tip and installation portion are free of foreign matter.
    2. Install the speed sensor without turning it from its original installation angle.

  1. Install the clamp onto the shock absorber with the bolt.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Install the clamp onto the body with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the 3 clips.

  1. Connect the speed sensor connector.

  1. Install the speed sensor clip onto the body.


2. INSTALL FRONT FENDER LINER
  1. Install the front fender liner with the 3 screws, 6 clips and 4 grommets.

    NOTICE:
    The speed sensor wire should not protrude beyond the front fender liner.


3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. CHECK ABS SENSOR SIGNAL
(Click here)
← INSPECTION (from Jan 2006)COMPONENTS (from Aug 2005) →