2005-2008 Yaris · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL STEERING SENSOR

C108994E01
  1. Engage the 6 claws and insert the 2 pins into the holes to install the steering sensor onto the spiral cable.


2. INSTALL SPIRAL CABLE

C118549
  1. Check that the ignition switch is turned to off.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached

  1. Confirm that the front tires face straight forward.

  1. Confirm that the turn signal switch is in the neutral position.

    NOTICE:
    Perform the operation when the turn signal switch is in the neutral position. Otherwise, the pin of the turn signal will break.

  1. Engage the 3 claws and install the spiral cable.

    NOTICE:
    Pull the lock pin out before installing the steering wheel, when replacing the spiral cable with a new one.

  1. B109372E01
    Connect the steering connector.

  1. Connect the airbag connector.

  1. Connect the horn connector.


3. INSTALL STEERING COLUMN COVER

C118548
  1. Engage the 2 claws and install the steering column cover (upper).

  1. Engage the 2 claws and install the steering column cover (lower).

  1. Tighten the 3 screws.


4. ADJUST SPIRAL CABLE

  1. B108279
    Center the spiral cable.

    1. Turn the spiral cable counterclockwise until it locks.

      HINT:
      The spiral cable turns a maximum of approximately 5 times.

    2. B108280E01
      Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.


5. INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

B108275E01
  1. Engage the 4 claws and install the steering column cover support.


6. INSTALL STEERING WHEEL ASSEMBLY

  1. C117210E01
    Align the matchmarks and install the steering wheel assembly onto the steering column assembly.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all connectors to the spiral cable.


7. INSTALL STEERING PAD (w/ Steering Pad Switch)

C117200E01
  1. Connect the horn connector.

  1. Connect the airbag connector.

    NOTICE:
    Securely lock the locking button.

  1. C121184
    Install the steering pad.

  1. Using "Torx" socket wrench T30, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


8. INSTALL STEERING PAD (w/o Steering Pad Switch)

C117196E01
  1. Connect the horn connector.

  1. Connect the airbag connector.

    NOTICE:
    Securely lock the locking button.

  1. C121183
    Install the steering pad.

  1. Using "Torx" socket wrench T30, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


10. INSPECT SRS WARNING LIGHT
(Click here)
← INSPECTION (from Aug 2005)COMPONENTS (from Nov 2005) →