2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE STEERING PAD (w/o Steering Pad Switch)

C128889
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136892
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128890E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn connector.


3. REMOVE STEERING PAD (w/ Steering Pad Switch)

C128888
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136891
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128891E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn connector.


4. REMOVE STEERING WHEEL ASSEMBLY

  1. C117210E01
    Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.

  1. C117207E01
    Using SST, remove the steering wheel assembly.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of the SST center bolt before using.


5. REMOVE STEERING COLUMN COVER

  1. w/o Entry and Start System:

    1. C118548
      Remove the 3 screws.

    2. Disengage the 2 claws and remove the steering column cover (lower).

    3. Disengage the 2 claws and remove the steering column cover (upper).

  1. w/ Entry and Start System:

    1. C136900
      Remove the 3 screws.

    2. Disengage the 3 claws and remove the steering column cover (lower) and steering column cover support.

    3. Disengage the 2 claws and remove the steering column cover (upper).


6. REMOVE SPIRAL CABLE

B109371E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.

  1. Detach the steering sensor connector.

  1. B108277E01
    Disengage the 3 claws and remove the spiral cable.


7. REMOVE STEERING SENSOR

C108994E01
  1. Disengage the 6 claws, and remove the steering sensor from the spiral cable.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →