2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

2. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)

C109005E01
  1. Disengage the 6 claws and remove the shifting hole cover.


3. REMOVE CONSOLE BOX REAR COVER

C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.


4. REMOVE CONSOLE BOX CARPET

C109008
  1. Remove the console box carpet.


5. REMOVE REAR CONSOLE BOX ASSEMBLY

C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.


6. REMOVE REAR WHEEL

7. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.

  1. F046068E02
    Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.


8. REMOVE REAR BRAKE SHOE KIT (for Rear Drum Brake)

C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.

  1. C108969E01
    Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
    SST
    09718-00010  

  1. Remove the tension spring.

  1. C108970
    Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.

  1. C108971E01
    Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
    SST
    09718-00010  

  1. C108972
    Using needle-nose pliers, separate the parking brake cable.


9. REMOVE FRONT FLOOR NO. 4 HEAT INSULATOR

C108997
  1. Remove the 2 nuts and remove the heat insulator.


10. LOOSEN NO. 1 WIRE ADJUSTING NUT

C116905E01
  1. Loosen the lock nut and the adjusting nut.


11. REMOVE PARKING BRAKE CABLE (for Rear Drum Brake)
  1. Disconnect the cable end from the equalizer.

  1. Remove cable clamp A from the body.

  1. Remove the 4 bolts.

  1. Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.

    C126201E01

  1. C109000
    Remove the bolt and remove the parking brake cable from the backing plate.


12. REMOVE PARKING BRAKE CABLE (for Rear Disc Brake)
  1. Disconnect the cable end from the equalizer.

  1. Remove cable clamp A from the body.

  1. Remove the 4 bolts.

  1. Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.

    C126201E01

  1. C112609
    Disconnect the cable end from the rear disc brake cylinder operation lever.

  1. C112608E01
    Insert offset wrench 14 all the way into the casing cap clip to flex the clip claws and remove the parking brake cable.

← COMPONENTS (from Aug 2005)INSTALLATION (from Aug 2005) →