2005-2008 Yaris · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL PARKING BRAKE SWITCH

C109013
  1. Install the parking brake switch with the screw.

    Torque:
    0.9 N*m{ 9 kgf*cm , 8 in.*lbf }


2. INSTALL PARKING BRAKE LEVER

C109012
  1. Install the parking brake pull rod and parking brake equalizer, and then provisionally install the adjusting nut and the lock nut.

  1. C109011
    Install the parking brake lever with the 3 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the parking brake switch connector.


3. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
  1. Connect the parking brake cable to the parking brake equalizer.


4. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Connect the parking brake cable to the parking brake equalizer.


5. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf, 45 lbf)


6. ADJUST PARKING BRAKE LEVER TRAVEL

C116905E01
  1. Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf, 45 lbf)

  1. Tighten the lock nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.


7. INSTALL REAR CONSOLE BOX ASSEMBLY

  1. B132349
    Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.


8. INSTALL CONSOLE BOX CARPET

  1. B132346
    Install the console box carpet.


9. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

  1. B132348
    Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.


10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B132347
    Engage the 5 clips and the claw and install the upper console panel.


11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

  1. B132388
    Install the shift lever knob.


12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER

B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REMOVAL (from Jan 2006)COMPONENTS (from Aug 2005) →