ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2005
| INSPECT FUEL CUT-OFF RPM |
Start and warm up the engine.
Increase the engine speed to approximately 3,500 rpm.
Using a sound scope, check the operation sound of the injector.
Release the throttle lever. Check that the operation noise stops momentarily and then resumes.
| VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
![]() ![]() |
Check that there are no cracks, leakage or scratches on the hoses, connections and gaskets.
- HINT:
- Removing the oil level gauge, oil filter cap or PCV hose may cause the engine to malfunction or stall.
- Disconnections, looseness or cracks in the parts of the air induction system between the intake system and cylinder head will allow air suction and cause the engine to run improperly.
- Removing the oil level gauge, oil filter cap or PCV hose may cause the engine to malfunction or stall.
| INSPECT VARIABLE RESISTOR (for Leaded Gasoline Specification Vehicle) |
![]() ![]() |
Remove the variable resistor.
Measure the resistance between terminals 1 (E2) and 2 (VC) of the variable resistor.
- Standard resistance:
Tester Connection
Specified Condition
E2 - VC
3.5 to 6.5 kΩ
Place matchmarks on the variable resistor.
Measure the resistance between terminals 1 (E2) and 3 (VAF) while turning the idle mixture adjusting screw fully clockwise and counterclockwise using SST.
- SST
- 09243-00020
- Standard resistance:
- Resistance oscillates between approximately 5 kΩ to 0 Ω accordingly
Align the matchmarks on the variable resistor.
Install the variable resistor.
| CHECK CO/HC (for Leaded Gasoline Specification Vehicle) |
![]() ![]() |
Warm up the engine to normal operating temperature.
Turn off all the accessories.
Connect all vacuum lines properly.
Shift the transmission to the N position.
Connect the tachometer.
Accurately measure the ignition timing.
Accurately check the idling speed.
Check that the CO meter is properly calibrated.
Race the engine at 2500 rpm for approximately 2 minutes.
Insert a tester probe at least 40 cm (1.3 ft) into the tail pipe.
Measure the concentration after racing the engine for 1 to 3 minutes to allow the concentration to stabilize.
- Idle CO concentration:
- 1.0 to 2.0 %
| INSPECT ECM (for Leaded Gasoline Specification Vehicle) |
![]() ![]() |
Disconnect the variable resistor connector.
Turn the ignition switch on (IG).
Measure the voltage between the terminals of the variable resistor.
- Standard voltage:
Tester Connection
Specified Condition
E2 - VC
4.5 to 5.5 V
Reconnect the variable resistor connector.





