2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006


1. INSTALL HEATED OXYGEN SENSOR

A115424
  1. Using SST, install the sensor onto the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. Pass the sensor connector through the floor panel and install the grommet.

  1. Connect the sensor connector.


2. INSTALL CONSOLE BOX ASSEMBLY REAR (for Hatchback)

C116873
  1. Engage the 2 clips and install the console box with the bolt.


3. INSTALL INSTRUMENT PAD LOWER LH (for Sedan)

  1. B132339
    Engage the claw and 3 clips and install the instrument pad lower.

  1. Install screw <I>.


4. INSTALL REAR CONSOLE BOX ASSEMBLY (for Sedan)

  1. B132349
    Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.


5. INSTALL CONSOLE BOX REAR COVER (for Hatchback)

C109006E01
  1. Engage the 8 claws to install the console box rear cover.


6. INSTALL CONSOLE BOX CARPET (for Sedan)

  1. B132346
    Install the console box carpet.


7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan)

  1. B132348
    Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.


8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan)

  1. B132347
    Engage the 5 clips and the claw and install the upper console panel.


9. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback)

C109005E01
  1. Engage the 6 claws to install the shifting hole cover.


10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)

  1. B132388
    Install the shift lever knob.


12. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for Sedan)

B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.


13. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan)

B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.


14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


15. CHECK FOR EXHAUST GAS LEAKAGE
← INSTALLATION (Aug 2005 – Dec 2005)COMPONENTS (from Aug 2005) →