INSPECTION
Inspection · Vehicles built from Nov 2006
| INSPECT INTEGRATION RELAY |
![]() ![]() |
Inspect the EFI fuse.
Disconnect the fuse.
Using an ohmmeter, measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
Inspect the EFI relay.
Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
A1 - C1
Below 1 Ω
A1 - A4
10 kΩ or higher
A4 - C1
10 kΩ or higher
A1 - A4
Below 1 Ω
(Apply battery voltage between terminals A2 and A3)
A4 - C1
Below 1 Ω
(Apply battery voltage between terminals A2 and A3)
- NOTICE:
- While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.


