REMOVAL
Removal / installation · Vehicles built from Nov 2006
- NOTICE:
- Replace the ECM with a new one if necessary.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WIPER ARM HEAD CAP |
![]() ![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.
| 3. REMOVE FRONT WIPER ARM LH |
Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
Remove the nut and front wiper arm.

| 4. REMOVE FRONT WIPER ARM RH |
- HINT:
- Use the same procedure as for the LH side.
| 5. REMOVE HOOD TO COWL TOP SEAL |
![]() ![]() |
Disengage the 7 clips and remove the hood to cowl top seal.
| 6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD) |
![]() ![]() |
Disengage the 2 hooks and remove cowl top ventilator louver center No. 1.
Disconnect the washer hose.

Disengage the 11 claws and clip.
Disconnect the washer hose and remove the cowl top ventilator louver sub-assembly.

| 7. REMOVE COWL TOP VENTILATOR LOUVER LH (for LHD) |
![]() ![]() |
Remove the 2 clips.
Disengage the 4 claws and remove the cowl top ventilator louver LH.
| 8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD) |
![]() ![]() |
Disconnect the washer hose.
Disengage the 10 claws and clip and remove the cowl top ventilator louver sub-assembly.
| 9. REMOVE COWL TOP VENTILATOR LOUVER LH (for RHD) |
![]() ![]() |
Remove the clip.
Disengage the 4 claws and remove the cowl top ventilator louver LH.
| 10. REMOVE FRONT WIPER MOTOR AND LINK |
![]() ![]() |
Remove the 2 bolts.
Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.
| 11. REMOVE NO. 2 COWL TO REGISTER DUCT SUB-ASSEMBLY |
![]() ![]() |
Disengage the claw and remove the No. 2 cowl to register duct sub-assembly.
| 12. REMOVE COWL TOP PANEL OUTER |
![]() ![]() |
Disengage the wire harness clamp.
Remove the 9 bolts and remove the cowl top panel outer.

| 13. REMOVE ECM |
Remove the 2 lock knobs and harness clamp.
Disconnect the 2 ECM connectors.

Remove the bolt and 2 nuts and remove the ECM.

| 14. REMOVE ECM BRACKET |
Remove the 2 screws and the ECM bracket.

| 15. REMOVE NO. 2 ECM BRACKET |
Remove the 2 screws and the No. 2 ECM bracket.










