2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2005


INSPECT ACCELERATOR PEDAL ASSEMBLY

  1. A107925
    Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / Accelerator Pedal Position No. 1 and Accelerator Pedal Position No. 2.

  1. While the accelerator pedal is depressed and released, check that the values of accelerator pedal position No. 1 and accelerator pedal position No. 2 are within the specification.

    Accelerator Pedal Position No. 1 Standard voltage:
    Condition
    Specified Condition
    Accelerator pedal released
    0.5 to 1.1 V
    Accelerator pedal depressed
    2.6 to 4.5 V

    Accelerator Pedal Position No. 2 Standard voltage:
    Condition
    Specified Condition
    Accelerator pedal released
    1.2 to 2.0 V
    Accelerator pedal depressed
    3.4 to 5.0 V

    HINT:
    If the results are not as specified, check the accelerator pedal, wire harness and ECM.

← COMPONENTS (from Aug 2005)REMOVAL (from Aug 2005) →