2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. A117319
    Install a vinyl hose onto the radiator side.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the water drain plug, then drain the coolant.

    A117375E01


3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

A116530E01
  1. Remove the 4 clamps.

  1. Remove the 2 clamps and remove the air cleaner cap.


4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

A116511
  1. Disconnect the 2 water by-pass hoses.

  1. Disconnect the connector.

  1. Remove the 4 bolts and the throttle body.


5. REMOVE THROTTLE BODY GASKET

A104785E01
  1. Remove the gasket from the intake manifold.


6. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

A104790
  1. Disconnect the connector.

  1. Remove the 2 bolts and manifold absolute pressure sensor.

← COMPONENTS (from Aug 2005)INSPECTION (from Aug 2005) →